Ъ©Ш§ШЁЩ„ micro usb to serial serial#

Note that the SPI pins are not connected to any of the digital I/O pins as they are on the Arduino Uno, they are only available on the ICSP connector and on the nearby pins labelled MISO, MOSI and SCK. These pins support SPI communication using the SPI library. Provide 8-bit PWM output with the analogWrite() function. See the attachInterrupt() function for details. These pins can be configured to trigger an interrupt on a low value, a rising or falling edge, or a change in value.

External Interrupts: 0(RX), 1(TX), 2 and 3.

Support TWI communication using the Wire library.

Ъ©Ш§ШЁЩ„ micro usb to serial serial#

Note that on the Micro, the Serial class refers to USB (CDC) communication for TTL serial on pins 0 and 1, use the Serial1 class. Used to receive (RX) and transmit (TX) TTL serial data using the ATmega32U4 hardware serial capability. In addition, some pins have specialized functions:

Each pin can provide or receive a maximum of 40 mA and has an internal pull-up resistor (disconnected by default) of 20-50 kOhms. It also has 2.5 KB of SRAM and 1 KB of EEPROM (which can be read and written with the EEPROM library).Д®ach of the 20 digital i/o pins on the Micro can be used as an input or output, using pinMode(), digitalWrite(), and digitalRead() functions. The ATmega32u4 has 32 KB (with 4 KB used for the bootloader). A 3.3 volt supply generated by the on-board regulator. This can come either from VIN via an on-board regulator, or be supplied by USB or another regulated 5V supply. The regulated power supply used to power the microcontroller and other components on the board. The input voltage to the Arduino board when it's using an external power source (as opposed to 5 volts from the USB connection or other regulated power source). If using more than 12V, the voltage regulator may overheat and damage the board. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. The board can operate on an external supply of 6 to 20 volts. Leads from a battery or DC power supply can be connected to the Gnd and Vin pins.

The power source is selected automatically.Д®xternal (non-USB) power can come either from a DC power supply or battery. The Arduino Micro can be powered via the micro USB connection or with an external power supply. Schematic: arduino-micro-schematic-rev3b.pdf Micro USB3.0 TO USB3.0 Female,Micro USB3.0 B to Micro USB3.0 B

This cable is used to connect your micro USB 3.0 Port of your Samsung Galaxy Note 3 N9000 to the USB3.0 Type A plug of your compatible USB3.0/2.0 device.

Connect to a keyboard for easier control of your Samsung Galaxy Note 3 N9000.

PC-free back up of videos and photos from Samsung Galaxy Note 3 N9000 to an external memory stick in a convenient way.

This USB3.0 Host adapter cable allows you to connect a USB3.0 memory stick, a USB3.0 /2.0 memory card reader, or a keyboard to your Samsung Galaxy Note 3 N9000.

Micro USB 3.0 OTG Cable, Model No: YT-MOTG301